Cisco - Access Point (no Gateway/Router)
• Data Transfer Rate: 300 Mbps
• Features: Access Control List (ACL) support , DHCP support , E-mail alert , Firmware upgradable , IPv4 support , IPv6 support , Load balancing , Multiple SSID support ,
Quality of Service (QoS) , RADIUS support , Spanning Tree Protocol (STP) support , Syslog support , VLAN support , Wall mountable , Wi-Fi Multimedia (WMM) support , Wi-Fi
Protected Setup (WPS) , Wireless bridge mode , Wireless Distribution System (WDS) support
• Network Transport Protocol: Bonjour , DHCP
• Power Over Ethernet (PoE): PoE See our PoE offerings (not included).
• Status Indicators: LAN , Power , WLAN
• Wi-Fi Bands: 2.4 GHz
• Wireless Protocol: 802.11b/g/n
• Number of Ports: 1 LAN , 0 WAN
• Interface Connector Type: RJ-45 (QTY 1), 100Base-TX, PoE
• Authentication Method: Radio Service Set ID (SSID) , RADIUS
• Encryption Algorithm: WPA , WPA2
• Mounting Kit: Included
• Antenna Form Factor: Internal integrated, Gain Level: 2 DBi
• Dimensions & Weight:
Depth: 4.9 in
Height: 1.4 in
Weight: 5.9 oz
Width: 4.9 in
Note: This is not a wired switch or router, so it requires an existing wired network to be setup or already in place. This is currently our preferred way to provide small range wireless in commercial or residential offices. No gateway means "all" your equipment, wired and wireless, can see each other on the network and work together without issues. Most gateway devices "will" eventually cause you some connectivity grief and cost more in the long run.
We do not warrant the product in any way, and no implied service contract is supplied with this purchase. We will complimentary answer questions resolved in 5 minutes or less, limited to 2x per month per account across all products and services. All other calls technical in nature will be billed at your normal account remote support rates in minimum 15 minute increments.
